Application Templates - Omron DeviceNet Safety NE0A Series Operation Manual

This appendix shows the NE0A-series Controller application templates supported by Network Configurator ver-
sion 2.10 or higher. Refer to Network Configurator documentation for information on the Network Configurator.
(Start the NE0A-series Setup Wizard and access the detail from the Application Template Setting Tab Page.)
Application Template 1
Safety category
4
Application Overview
Motor M stops when emergency stop pushbutton S1 is pressed.
Wiring Diagram
Note (1) Connect a 24-VDC power supply to terminals V0 and G0 (power supply terminals for internal circuits).
(2) This example shows the NE0A-SCPU01 Controller's terminal layout.
Timing Diagram
Reset ON
E-STOP S1
11-12
E-STOP S1
21-22
Reset S2
KM1
KM2
EDM
feedback
Appendix A

Application Templates

Safety device
Emergency stop pushbutton
E-STOP release
E-STOP push
More than
350 ms
Stop category
0
E1 and E2: 24-VDC power supplies
S1: Emergency stop pushbutton
S2: Reset switch
KM1and KM2: Contactors
M: Motor
Discrepancy error
Discrepancy
error release
More than
350 ms
Reset
Manual
EDM error release
More than
350 ms
EDM error
151