Omron DeviceNet Safety NE1A-HDY01 Operation Manual page 74

Replacing a Device
IMPORTANT A device password cannot be set with the Mobile Console. Set the device
Note
Serious personal injury may possibly occur due to loss of safety functions.
Observe the following precautions.
After replacing a device, check to make sure that the replacement device is in
the appropriate configuration and is operating correctly
9. To lock the configuration, tap the Yes Button.
If the device was in RUN mode before being replaced, the following dialog
box will be displayed.
10. Tap the Yes Button or the No Button.
• Tapping the Yes Button will set the device to RUN mode.
• Tapping the No Button will keep the device in IDLE mode.
11. Tap the OK Button.
This completes replacing the device.
12. Tap the OK Button.
The display will return to the Main Window.
password from the Network Configurator.
Devices can also be replaced in the same way by using the following proce-
dure: Upload the parameters and save them to a file, replace the device,
download the parameters, and then lock/unlock the configuration.
!WARNING
Section 3-3
51