Wiring Precautions - Omron K3MA-F Datasheet

Installation
1. Insert the K3MA-F into the panel cut-out hole.
2. For a waterproof installation, insert the rubber gasket onto the
body of the K3MA-F.
3. Fit the adaptor into the grooves on the left and right sides of the
rear case, then push it until it contacts the panel to secure the
K3MA-F.

■ Wiring Precautions

• Use crimp terminals.
• Tighten the terminal screws to a torque of approximately 0.5 N ⋅ m.
• To avoid the influence of noise, route signal lines and power lines
separately.
■ Wiring
• Use the following M3 crimp terminals.
■ Unit Labels (Provided)
• The unit labels are not attached to the K3MA-F. Select the desired
labels from the provided sheet.
5.8 mm max.
5.8 mm max.
Note: For scales and gauges, use the unit labels that are specified by
the relevant laws or regulations.
Frequency/Rate Meter
K3MA-F
11