Omron H3DS Manual page 38

■ Wiring
Use wires of the applicable sizes specified above. The length of the
exposed conductor should be 6 to 7 mm.
Fig. 1 Exposed Conductor Length
Use the following wiring procedure.
1. Insert the specified screwdriver into the release hole located
beside the wire connection hole where the wire is to be inserted.
Wire
connection
holes
Release
holes
Fig. 2 Wire Connection Holes and Release Holes
Fig. 3 Section A-A of Fig. 2
2. Insert the exposed conductor into the wire connection hole.
3. Pull out the screwdriver.
B-46
Common to All Timers
6 to 7 mm
A
A
Wire connection hole
Release hole
Screwdriver
Insert
Insert
H3DS-@LC
■ Precautions
Always insert the screwdriver straight into the hole, never at an angle.
The clamp spring may be deformed if the screwdriver is not straight.
Do not move the screwdriver side to side in the clamp hole. The
clamp spring may be deformed if the screwdriver is moved sideways.
Insert
Pull out