Mounting The Controller; Horizontal Mounting - Omron F250-C50 C55 - SETUP 09-2001 Manual

Mounting the Controller

2-4

Mounting the Controller

There are two ways to mount the Vision Mate Controller: horizontal mounting,
or vertical mounting. (All dimensions are in mm.)
F250 Dimensions
270
(25)
220
–
190
(40)
2-4-1

Horizontal Mounting

For proper air flow, provide at least 20 mm of clearance from the top of the
Controller and at least 50 mm of clearance from the sides (next to the intake
and exhaust vents).
50 min.
(Intake)
–
0.6
Four M4 taps
(for mounting)
0.6
20 min.
This screw hole
115 min.
cannot be used.
–
The screw length L must be
in the following range:
10+T < L < 13+T
CHECK
Use the correct screw length. If
the screw extends more than 13
mm past the panel, the stopper
may bend and contact the
Controller's internal PC board.
115 min.
50 min.
(Exhaust)
Section 2-4
197
Stopper
10 to 13
Panel
thickness: T
This screw hole
cannot be used.
20 min.
8 mm
15