Sending Operation Commands To The Temperature Controllers - Omron EJ1 - 07-2008 Operation Manual

Operations from the Edit Device Parameters Window
5-2-8

Sending Operation Commands to the Temperature Controllers

Operating Method
1,2,3...
3. Select the channel from which to copy, specify the unit number and chan-
nel as the copy destination, and then click the OK Button. The parameters
will be copied and the display will return to the Edit Device Parameters
Window for the DeviceNet Communications Unit.
4. From the Edit Device Parameters Window, select the General Tab, and
click the Download Button to write all the parameters copied from the Tem-
perature Controller.
The Configurator can be used to send operation commands to each of the
Temperature Controllers through the DeviceNet Communications Unit.
The following operation commands can be executed from the Configurator.
• RUN/STOP
• Alarm latch cancel
• Auto/manual
• Initialize settings
• AT execute/cancel
• Software reset
• LSP/RSP switching
• Clear error
• Write mode
1. Open the Edit Device Parameters Window for the DeviceNet Communica-
tions Unit, select the General Tab, and click the Operation Button for the
Temperature Controller unit number in the Unit Configuration field.
Section 5-2
91