Connection Procedure; Operation Flow - Omron V460-H Series Connection Manual

7. Connection Procedure

This section describes the procedures for connecting the controller to an Ethernet network.
In this document, it is assumed that the controller and the code reader use the factory default
settings. For how to initialize the devices, refer to Section 8. Initializing the System.

7.1. Operation Flow

The procedures for connecting and setting up the controller via Ethernet are as follows.
7.2. Code Reader Setup
▼
7.2.1. Setting the Parameters

7.3. Controller Setup
▼
7.3.1. Starting the Sysmac Studio and
Loading the Project File
▼
7.3.2. Checking Parameters and
Executing Builds
▼
7.3.3. Going Online and Transferring
the Project Data

7.4. Checking the Connection Status
▼
7.4.1. Executing the Project File and
Checking the Receive Data
Precautions for Correct Use
Obtain the latest version of the Sysmac Studio Project File from OMRON in advance.
(Contact OMRON for information on how to obtain this file.)
7. Connection Procedure
Set up the code reader.
Set the parameters for the code reader.
Set up the controller.
Start the Sysmac Studio Automation Software and
load the Sysmac Studio Project File.
Check the setting parameters. Then, perform
program checks and builds on project data.
Place the Sysmac Studio online and transfer the
project data to the controller.
Execute the transferred project file to check that
Ethernet communications work correctly.
Execute the project file and check that correct data
is written to controller variables.
10