Modifying A Plc Connection; Removing A Plc Connection - Omron CX-SUPERVISOR - V2.0 User Manual

CHAPTER 6 – Projects
Note:
If a timeout occurs, the communication is not complete. Where necessary, increase the Timeout
Offset value (in milliseconds) to ensure that the device does not cause a timeout.
Values specified may be set as default by clicking the Make Default pushbutton.

Modifying a PLC Connection

From the Setup Devices dialog, a PLC name may be modified by selecting the PLC name from the
Device List on the Setup Devices dialog, and clicking the Modify pushbutton. This results in the
Change PLC dialog being displayed.
A new name can be entered in the PLC Name: field. If an invalid PLC name is entered, an error
message is displayed on clicking the OK pushbutton.

Removing a PLC Connection

From the Setup Devices dialog, a PLC name may be removed from the PLC Name: field by selecting
the PLC name from the Device List on the Setup Devices dialog, and clicking the Delete pushbutton.
This results in a confirmation dialog being displayed. Click the Yes pushbutton to remove the PLC
from the list, or the No pushbutton to abort the delete operation.
Note:
Page 82
The possible settings for the Baud Rate, Parity, Data Bits, and Stop Bits fields
depend upon the port selected.
A PLC cannot be renamed, deleted or edited if it is currently open for
communications.
OMRON
Release 2.0