Omron CX-ONE - INTRODUCTION GUIDE Introduction Manual page 67

3. Comparison of Functions between Conventional Support Software and
3. Comparison of Functions between Conventional Support Software and
CX-One (2/2)
CX-One (2/2)
Function
Network DeviceNet
setting
CompoWay/F
Routing Table
(Note)
I/O Table can be started from CX-Programmer or CX-Integrator on CX-One.
Conventional Support Software
Fixed assignment by Fixed assignment: No setting tool
DeviceNet, or free (by edit on PLC memory).
assignment by Free assignment: By DeviceNet
assignment DM. configurator.
Free assignment By DeviceNet configurator.
and Slave parameter
setting/monitoring by
DeviceNet
configurator
CompoWay/F Slave By CX-Thermo
station parameter
setting
By CX-Net (Routing Table
Component) in CX-Programmer.
CX-One
Fixed assignment: By right-clicking on a
DeviceNet Unit of the I/O Table online or
offline and selecting [Unit Setup].
Free assignment: By right-clicking on a
DeviceNet Unit of the I/O Table through
online or offline CX-Integrator and selecting
[Edit Parameters].
By right-clicking on a DeviceNet Unit of the
I/O Table and selecting [Start Special
Application] for device parameter edit.
Temperature controller: By right-clicking on
a target Unit through online or offline CX-
Integrator and selecting [Start Special
Application] to start CX-Thermo and edit the
setting.
Smart sensor: By right-clicking on a target
Unit through online or offline CX-Integrator
and selecting [Edit Parameters] to edit.
By selecting [Tools] > [Start Routing Table]
from CX-Integrator to use Routing Table
Component.