Omron CX-ONE - INTRODUCTION GUIDE Introduction Manual page 33

Online Debug on
Reading
a Machine
Click
Click
Click [Online] > [Test Run]
Online
Connection
Project
to PLC
The Unit restart confirmation screen will be displayed during data transfer. Click the [OK]
button after confirming safety. Also, in the case of communication was not established
between the NCF Unit and the servo driver, confirm the axis number and restore power to
the NCF Unit and servo driver.
When parameter transfer is completed, confirm that communications is performed normally and
has not resulted in an error.
Monitor the NCF Unit. Confirm consistent scan list (axis configuration) and communications
status and that no axis or common Unit error has resulted.
Next, perform jog operation. Carefully read the displayed cautions, then perform the operation.
To perform jog operation, it is required to establish a connection, servo lock, and jog setting.
Transferring
Program
to a
Debug
Machine
Terminate
Unit monitoring.