Omron CX-ONE - INTRODUCTION GUIDE Introduction Manual page 34

Online Debug on
Reading
a Machine
Click
Select file .mnh
Click [Open]
Click
Click
Select [All Data]
Select [With Servo
Parameter]
Click [OK]
Online
Connection
Project
to PLC
When using the MCH Unit, transfer data from the CX-Motion-MCH to the MCH Unit and servo
driver connected to the MCH Unit.
[Data to be transferred]
MCH Unit: parameter, position data, program, CAM data.
Servo driver: servo parameter
Display the I/O table from CX-Programmer and start CX-Motion-MCH with [Start Only].
(Refer to NCF Unit for starting from the I/O table.)
Open the saved project and transfer Unit parameter, position data, program, CAM data, and
servo driver parameters to the MCH Unit.
To prevent a servo driver operation using a ladder program, you must set the
PLC to PROGRAM mode.
The Unit restart confirmation screen will be displayed during data transfer. Click the [OK] button
after confirming safety. Also, in the case of communication was not established between the
MCH Unit and the servo driver, confirm the axis number and restore power to the MCH Unit
and servo driver.
Transferring
Program
to a
Debug
Machine
If it does not go online, double-
click PLC in the project tree and
check the communication
settings between the personal
computer and PLC.