Omron CJ - 08-2008 Operation Manual page 376

PLC Setup
Pulse Output 1 Origin Proximity Input Signal Type
Programming Settings
Console
address
Word Bits
+286 04 to 07 0 hex: NC
1 hex: NO
Pulse Output 1 Origin Input Signal Type
Programming Settings
Console
address
Word Bits
+286 08 to 11 0 hex: NC
1 hex: NO
Pulse Output 1 Undefine Origin Setting (CJ1M CPU Unit Ver. 2.0 Only)
Programming Settings
Console
address
Word Bits
+286 12 to 15 0 hex: Hold
1 hex: Undefine
Pulse Output 1 Positioning Monitor Time
Programming Settings
Console
address
Word Bits
+287 00 to 15 0000 to 270F hex
(See note.)
328
Default
0 hex Specifies whether the Origin Proxim-
ity Input Signal for pulse output 1 is
normally closed or normally open.
Default
0 hex Specifies whether the Origin Input
Signal for pulse output 1 is normally
closed or normally open.
Default
0 hex Specifies whether to hold the origin
setting when the CW/CCW limit input
signal is input during execution of an
origin search or pulse output function.
Default
0000 Specifies the positioning monitor time
hex (0 to 9,999 ms) for pulse output 1.
Note When the CX-Programmer is being used to make the setting, the setting is
input in decimal.
Function
Area flags/
---
Function
Area flags/
---
Function
Area flags/
---
Function
Area flags/
---
Section 7-1
Related Time when
Auxiliary setting is read
by CPU Unit
bits
When operation
starts
Related Time when
Auxiliary setting is read
by CPU Unit
bits
When operation
starts
Related Time when
Auxiliary setting is read
by CPU Unit
bits
When operation
starts
Related Time when
Auxiliary setting is read
by CPU Unit
bits
When operation
starts