Introduction; Proper Use - Parkside PWS 1200 - MANUAL 2 Operation And Safety Notes

Introduction

The following pictogrammes / symbols are used in these operating instructions:
Read the operating instructions!
Always heed warning labels and
safety instructions!
Caution - Danger of electric shock! Hazardous
voltage – danger to life!
Explosive material!
Risk of fire!
Soft start to limit heavy transient current surges
V ~
Volt (AC)
W
Watts (effective power)
Angle grinder PWS 1200
Grinding, roughing, cutting
and polishing
Introduction
Please make sure you familiarise your-
self fully with the way the device works
before you use it for the first time and
that you understand how to handle electrical pow-
er tools correctly. To help you do this please read
the accompanying operating instructions. Keep
these instructions in a safe place. If you pass the
device on to anyone else, please ensure that you
also pass on all the documentation.
30 GB/MT
n
Rated idle running speed
0
Protection category II power tool;
double insulated
Proper procedure and handling.
Wear hearing protection, dust protection mask,
protective glasses and protective gloves.
Keep children and other unauthorised personnel
at a safe distance when using electrical tools.
Keep the device away from rain or moisture.
Water entering an electrical device increases the
risk of electric shock.
Damaged appliances, power cables and power
plugs mean potentially fatal risks from electric
shock. Regularly check the condition of the appli-
ance, the power cables and the power plugs.
Dispose packaging and appliance in an
environmentally-friendly way!

Proper use

The device is intended for the dry cutting, rough
grinding and brushing of metal and stone. With
approved types of abrasive consumables and tools
the device can also be used for finish grinding and
polishing. Any other use or modification to the
device shall be considered as improper use and
could give rise to considerable dangers. We will
not accept liability for loss or damage arising from
improper use. The device is not intended for com-
mercial use.
Note: Slots cut in load-bearing walls must comply
with standard DIN 1053 Part 1 or the regulations
applicable in your country.
These instructions and advice must be observed.
Before you start a task, seek the advice of a com-
petent structural engineer, architect, or the relevant
site management staff.