Switching On The Device; Switching Off The Device; Preselecting The Speed; Advice On Use - Parkside KH 3113 ELECTRIC SCRAPER/CARVER Manual

First Use
í

Switching on the device

Press the ON/OFF switch
Note: The device will not start its working action
until it is in contact with the material.
í

Switching off the device

Press the ON/OFF switch
í

Preselecting the speed

Q
The wheel allows you control of the speed over
the full range available.
Setting 1 = slowest speed, e.g. for detailed
or precise tasks
Setting MAX. = fastest speed, for removing
material quickly
Note: The optimum speed depends on the material
and the surface to be worked. It is best determined
by a short practical test. Always begin by using the
slowest speed setting. If you fi nd that you are not
removing enough material, increase the speed by
one setting.
í

Advice on use

½
Warning! Always pull out the mains plug from
the socket:
- when you are no longer using the device
- when taking a break from your work
- before changing the tool attachment
- before cleaning the device
Caution! Keep other people out of your work-
ing area.
½
Always hold the workpiece fi rmly with both
hands (see Fig. B) and always work away from
your body.
½
Guide the switched on device slowly with
the tool attachment up to the material to be
worked or surface to be stripped. The device
will not begin its working action until it makes
8 UK
W
into setting "I".
W
into setting "0".
contact with the material to be worked. This
allows you to position the tool exactly.
½
Begin at the fl attest possible angle and lightest
pressure.
½
Note that if you press on to backgrounds like
tiles, wood or plaster too hard you could dam-
age them.
½
The device and the tool attachment heat up
if used for long periods. Do not overload the
device and let it cool between sessions.
í

Resharpening tool attachments

Your tools must be sharp to achieve the best
results. You should therefore resharpen or regrind
them at the right time.
There are two ways of sharpening your tools:
1. with a bench grinder
(e.g. Parkside PDS 200):
½
Rotate the electric scraper/carver with an
inserted tool attachment through 180°.
½
Attention! Do not switch on the electric
scraper/carver.
Make sure that no blue colour (annealed
colour) appears on the cutting edge during
resharpening, otherwise the hardness can be
adversely affected.
2. with a belt sander
(e.g. Parkside PEBS 900):
½
Mount the belt sander in a suitable stationary
holding device.
½
Rotate the electric scraper/carver with an
inserted tool attachment through 180°.
½
Attention! Do not switch on the electric
scraper/carver.
Pay attention to the direction of motion of the
belt sander when resharpening.