If A Problem Occurs; Restoring Factory Default Settings (Reset); Resets The Headset To The - Sennheiser VMX 200 Instruction Manual

If a problem occurs ...

20 | VMX 200
If a problem occurs ...
Problem
Headset cannot
be switched on
No audio signal
Headset cannot
be paired
Headset does
not react to any
button press
If a problem occurs that is not listed in the above table or if the problem
cannot be solved with the proposed solutions, please contact your local
Sennheiser partner for assistance.
To find a Sennheiser partner in your country, search at www.senncom.com.

Restoring factory default settings (Reset)

You can restore the following settings to their factory default settings:
• list of paired Bluetooth devices (afterwards empty)
Set the headset to pairing mode (see page 10). The LED flashes alter-
nately blue and red, indicating that the headset is in pairing mode.
3 s
Simultaneously press and hold the volume up button and the volume
down button for 3 seconds.
Possible cause Possible solution
The rechargeable Recharge the recharge-
battery is flat. able battery.
The headset is not Check if the headset is
paired with the paired. If necessary, pair
mobile phone. the headset with the
mobile phone again.
The volume is Increase the volume.
adjusted too low.
The headset is Switch the headset on.
switched off.
The pairing does Check if the your
not work. Bluetooth device
supports the HF or
HS profile.
The mobile phone Switch the mobile
is switched off. phone on.
The operation of the Reset the headset to
headset is faulty. the factory default
settings.
Vol +
Vol –
Page
9
14
15
14
–
14
20