Adjusting The Low-Cut Frequency - Lowcut; Selecting The Standard Display - View; Loading The Factory-Preset Default Settings - Reset - Sennheiser SKM 5200 Instructions For Use Manual
Hide thumbs
Also See for SKM 5200:
- Product sheet (3 pages) ,
- Specification (1 page) ,
- Specification (1 page)
Table of Contents
Advertisement
Microphone sensitivity of the SKM 5200 and the SKM 5000:
SKM 5200:
Setting in dB
SKM 5000:
Switch position
Adjusting the low-cut frequency –
To reduce unwanted low-frequency noise such as engine, wind
and rumble noise, you can activate a low-cut filter. The low-cut
frequency can be set to 190 Hz or 120 Hz.
If you do not want to reduce low-frequency signal portions, select
the setting "FLAT".
Selecting the standard display –
Via the "VIEW" menu, you can select one of the following standard
displays:
CH
Transmission
frequency "FREQ"
The selected standard display is shown
after switch-on,
after the menu settings have been displayed in display mode.
Loading the factory-preset default settings –
Via the "RESET" menu, you can load the factory-preset default
settings. After the reset, the standard display is shown on the
display panel.
Low-cut frequency
Microphone sensitivity
Name
Standard display
Autolock function
Channel
Frequencies in the channel bank "VAR" are reset
26
–40
1
RF
MHz
Channel
"CHAN"
–30
–20
2
3
LOWCUT
VIEW
RF
CH
CH
Name
"NAME"
flat
–20 dB
5200
frequency
deactivated
FIX 01
–10
0
4
5
RF
RESET
Advertisement
Table of Contents
