Adjusting The Microphone Sensitivity - "Atten; Adjusting The Low-Cut Frequency - "Lowcut; Selecting The Standard Display - "View - Sennheiser SKM 5200-II Instruction Manual

Adjustment tips for the operating menu
Adjusting the microphone sensitivity –
"ATTEN"
Via the "ATTEN" menu, you can adjust the radio microphone's sensitivity
by changing its input attenuation.
dB
The bargraph has a resolution of approx. 3 dB per segment with a
display range of 45 dB.
Adjusting the low-cut frequency –
"LOWCUT"
To reduce unwanted low-frequency noise such as engine, wind and rumble
noise, you can activate a low-cut filter. The low-cut frequency can be set to
190 Hz or 120 Hz.
If you do not want to reduce low-frequency signal portions, select the set-
ting "FLAT".
Selecting the standard display – "VIEW"
Via the "VIEW" menu, you can select one of the following standard dis-
plays:
CH
Transmission frequency
"FREQ"
The selected standard display is shown
• after switch-on,
• after the menu settings have been displayed in display mode.
26
The input attenuation is correctly adjusted
when the level display for audio signal "AF"
RF shows full deflection
AF
dest passages. The input attenuation can be
adjusted in 1-dB steps from –40 dB to 0 dB.
RF
MHz
Channel
"CHAN"
RF
CH
CH
Name
"NAME"
only during the lou-
RF