Connecting The Transmitter To The Mains; Using The Set 900 - Sennheiser SET 900 - 07-08 Instruction Manual

Using the Set 900

Connecting the transmitter to the mains

Q
EU UK
Notes:
– When connecting the transmitter to the mains
for the first time, charge the rechargeable
battery for 3 hours as described in the chapter
"Storing and charging the receiver" on
page 17.
– If there is no audio signal from the sound source
for about 3 minutes, the transmitter automatically
switches off. The operation indicator
Using the Set 900
To switch the Set 900 system on, proceed as follows:
1. Switch your sound source (e.g. TV) on. The transmitter
automatically switches on (see next chapter).
2. Put the stethoset receiver on. The receiver automatically
switches on (see page 12).
3. Adjust the desired volume (see page 14).
4. When using the receiver without the transmitter on the
move, search for your sound source (see page 12).
10
P
US
I
P
Select the suitable country
Q
adapter
socket.
Plug the suitable country
adapter onto
P
unit .
Connect the yellow connector
of the mains unit to the yellow
I
socket on the transmitter.
Plug the mains unit
wall socket.
The operation indicator
on the transmitter lights up
green.
C
for your wall
the mains
P
into a
C
3h
goes off.