Changing The Operating Mode - Sennheiser SET 830 S Instruction Manual

Changing the operating mode

The transmitter can be set to a different operating mode. This is useful
when the sound of your sound source is very low and the transmitter
therefore does not always switch on automatically.
D
C
green:
Particularities of operating mode 2:
In operating mode 2, the transmitter is
signal from the sound source.
To switch the transmitter on:
Take the receiver out of the charging compartment.
To switch the transmitter off:
Place the receiver into the charging compartment.
If – in operating mode 2 – you want to use a second receiver and charge
its rechargeable battery during operation:
6
9
Press the "speech intelligibility" button
for approx. 5 seconds.
The indicator
cator for the spare rechargeable battery
flashes several times:
red: operating mode 2
operating mode 1 (factory-preset)
If the operating mode was changed success-
fully, the charging indicator for the spare
rechargeable battery
indicator
0
Pull the battery out of the receiver's battery
compartment
Slide the battery into the transmitter's
charging compartment
Additional technical information
D
goes off. The charging indi-
0
D
lights up again.
not switched on by the sound
6
.
9
C
goes off and the
as far as it will go.
0
29