Table of Contents
Advertisement
Using the devices
16
Using the devices
To establish a transmission link, proceed as follows:
1. Switch the transmitter on.
2. Switch the diversity receiver on.
The transmission link is established.
It is vital to observe the notes on frequency selection on page 27.
If you cannot establish a transmission link between transmitter and receiver:
Make sure that transmitter and receiver are set to the same frequency bank and to the
same channel – the easiest way is to synchronize the devices (see page 20).
If necessary, read the chapter "If a problem occurs ..." on page 29.
Switching the devices on/off
Switching the SR 300 IEM G3 transmitter on/off
To switch the transmitter
on
Press the
STANDBY
The transmitter switches on and the standard display appears.
The transmitter transmits an RF signal and the transmission icon
To switch the transmitter
on
Press the
STANDBY
Press the jog dial.
The transmission frequency is displayed but the transmitter does not transmit
an RF signal. The transmission icon
backlighting changes from orange to red and
with the standard display.
Use this function to prepare a transmitter for use during live operation without
causing interference to existing transmission links.
To
activate
the
RF
signal:
Briefly press the
"RF Mute
Off" appears on the display panel.
Press the jog dial.
The transmission icon
To switch the transmitter to
If necessary, deactivate the lock mode (see page 18).
Keep the
STANDBY
The transmitter switches to standby mode.
(online operation):
button
.
and to
deactivate the RF signal on switch-on
button
until
"RF Mute
is not displayed. In addition, the display
STANDBY
button
.
is displayed again.
standby
mode:
button
pressed until "OFF" appears on the display panel.
is displayed.
(offline operation):
On?" appears on the display panel.
"RF
Mute" flashes in alternation
Advertisement
Table of Contents
