Table of Contents
Advertisement
A
Loop Out
BAL
+22dBu
BAL
MAX
AF IN
L(I)
R(II)
L(I)
R(II)
+22dBu MAX
RF OUT
B
Loop Out
BAL
+22dBu
BAL
MAX
AF IN
L(I)
R(II)
L(I)
R(II)
+22dBu MAX
RF OUT
C
Loop Out
BAL
+22dBu
BAL
MAX
AF IN
L(I)
R(II)
L(I)
R(II)
+22dBu MAX
RF OUT
Stereo Transmitter SR 3
FREQ Range-D 780-822 MHz
IDENT NO 627925
0682
SER NO 2518100155
IC 2099A-G3SREK
DESIGNED AND MADE IN GERMANY
FMO
Loop O
BAL
+22dBu
MAX
L(I)
Daisy chaining audio signals
You can transmit the same audio signal (e.g. the sum of all audio signals) to several diversity
receivers of a multi-channel system. To do so, you have to daisy chain this audio signal from
one transmitter to the next via the output sockets
LOOP OUT BAL R(II)
. The audio signal is then transmitted by all transmitters on one of the
two audio channels L(I) or R(II). The second audio channel allows you to transmit an
individual audio signal (e.g. the instrument of a musician). Using the balance setting on the
receiver, you can then adjust the relative levels of the sum of all audio signals and the
individual audio signal. For this, the transmitter has to be set to stereo mode and the receiver
to Focus mode.
To daisy chain an audio signal from one transmitter to the next:
Route a signal from the mixing console to the input socket (in this example:
BAL AF IN R(II)
) of transmitter A.
Connect the output socket
BAL AF IN R(II)
of transmitter B.
Connect the output socket
BAL AF IN R(II)
of transmitter C.
Repeat for the other transmitters.
The AF output sockets
only when the transmitter is switched on and powered (see page 12).
Connecting transmitters in a network
You can connect several transmitters in a network. The transmitters are remote controlled via
a PC running the
"Wireless Systems
the quick and safe configuration of multi-channel systems.
The
"Wireless Systems
corresponding product page on our website at www.sennheiser.com.
Connect a standard network cable (at least Cat 5) to the LAN socket
Connect your transmitter to an Ethernet switch.
Connect the other transmitters to the Ethernet switch.
Connect a PC to the Ethernet switch.
When a transmitter is properly connected to the Ethernet switch or the PC, the yellow
LED
at the rear of the transmitter lights up.
For further information on network operation using the WSM software, refer to page 27.
Putting the devices into operation
LOOP OUT BAL R(II)
of transmitter
LOOP OUT BAL R(II)
of transmitter
LOOP OUT BAL L(I)
and/or
Manager" (WSM) software. This software will assist in
Manager" (WSM) software can be downloaded from the
LOOP OUT BAL L(I)
A
to the input socket
B
to the input socket
LOOP OUT BAL R(II)
will work
of the transmitter.
or
13
Advertisement
Table of Contents
