Identifying Devices - Sennheiser Dante SL DI 4 XLR Instruction Manual

Identifying devices

If you are using several SL DI 4 XLR devices and want to know which device in the software corres-
ponds to which hardware in your installation, you can use the Identify function.
Tick the Identify check box at the right of the navigation bar.
All four PAD LEDs flash on the corresponding SL DI 4 XLR.
The Dante Debug Mode
In Dante Debug Mode, the LEDs at the front of the SL DI 4 XLR indicate the diagnostic status.
After start-up of the SL DI 4 XLR, the diagnostic status is displayed for approx. 20 seconds before
the level and phantom power settings are shown.
To manually display the diagnostic status::
Tick the Dante Debug Mode check box in the lower left corner of the configuration window.
The SL DI 4 XLR Dante™ interface
SL DI 4 XLR 9/11