Table of Contents
Advertisement
ITC222-EN
17/07/03
16:59
Adjusting the convergence
Retour
‹ Auto convergence
Red convergence
Blue convergence
To go to Auto convergence menu,
press ¦ or ‹ .
Auto convergence
This function can be used to automatically adjust the convergence.
1.
If your set has this function, the Auto convergence menu appears after automatic set-up.
2.
Press
to start the auto convergence process, which lasts about one minute.Once the process is complete the
Centre converg. screen appears.
If you want to interrupt the process and restore the previous values, press the
Centre Convergence
This function can be used to adjust the convergence manually. Screens differ according to whether the set has the
Autoconvergence function or not.
1.
If your set has the Auto convergence function:
The Red centre convergence screen appears after the Auto converg. screen. Leave the projection
a.
television on the same channel for about ten minutes before adjusting the convergence.
Use the
b.
yellow cross. Press
Use the
c.
turquoise cross. Press
The Contact us! screen then appears.This displays the Thomson Europe website address and Helpline telephone
d.
number (see page 2), as well as your TV set's serial number.
2.
If your set does not have the Auto convergence function:
The Red centre convergence screen appears after the Organiser menu. Leave the projection television on
a.
the same channel for about ten minutes before adjusting the convergence.
Use the
b.
give three yellow crosses. Press
Use the
c.
give three turquoise crosses. Press
The Contact us! screen then appears.This displays the Thomson Europe website address and Helpline telephone
d.
number (see page 2), as well as your TV set's serial number.
Notes:
- During the initial set-up the procedure must continue uninterrupted until the
the whole procedure again the next time you switch on the TV set.
- The screens for adjusting the convergence automatically appear after the automatic channel set-up process is complete. To access them another
time, press the
MENU
then choose the required function from the
- The
Contact us!
screen appears automatically after the initial set-up is complete. To access it later on, press
OVERVIEW
menu, select
Page 9
...
...
...
These settings only apply to projection televisions.
buttons to move the red cross so that it becomes superimposed on the green cross to give a
.The Blue centre convergence screen then appears.
OK
buttons to move the blue cross so that it becomes superimposed on the green cross to give a
.
OK
buttons to move the red crosses so that they become superimposed on the green crosses to
.The Blue centre convergence screen then appears.
OK
buttons to move the blue crosses so that they become superimposed on the green crosses to
.
OK
button to display the
OVERVIEW
Convergence
Contact us!
and press
OK
Your projection television is equipped with three coloured projection
tubes, one each for red, green and blue.The images (red, green and blue)
are projected onto the screen where they converge to form a single
colour image.You must adjust the convergence during initial set-up. It is
possible later on that the convergence will go out of alignment after a
certain period of operation or as a result of vibration (if you have moved
the TV set, for instance).This page explains this procedure.
OK
Contact us!
screen appears. Otherwise, you will have to start
menu and select
Installation
. Select
menu.
.
9
Channel set-up
button.
Convergence
from the
Install.
to display the
MENU
EN
menu,
Advertisement
Table of Contents
