Table of Contents
Advertisement
ITC222-EN
17/07/03
16:59
Chapter 3
General operation
Switching the TV set on and off
To switch the TV set on, press the
is green.To switch off the TV set, press this button again.
Standby mode
Press the
button on the remote control.When the set is in standby mode, the indicator on the front is red.The TV set
remains powered up, but with low energy consumption.
Quitting standby mode
- press the
or any numeric button on the remote control,
- press the
,
or
TV
OK
- press the
button to switch the television on at the last AV programme you were watching.
AV
Volume
Volume control: use the
increase or decrease the volume.
Sound mute: press the
Headphone volume control: press the
buttons to switch to the headphone volume control bar. Use the
Displaying status information
In TV mode, press the yellow button (
watching, the time, the type of sound, the zoom or format, and the status of the Parental control function.
If the programme guide is available for this channel, the name of the programme currently showing is displayed, along with
its start time and duration and the name and start time of the following programme are also displayed.
When you switch on the television or change channels, the number and name of the channel are displayed.
Note: If you activate the
(see page 19).
Accessing channels
Using the numeric buttons:
- for channels 1 to 9, press the corresponding button;
- for channels 10 to 99,
- press the tens digit for a few seconds to display it on the screen, then press the units digit. For instance, for
programme 24, press and hold 2 to display 2-, then press 4; or
- press the 0 button to display "--", then enter the two digits.
+/
- buttons: scroll through the channels. AV programmes are not included in the cycle unless you use the
Using the
PR
PR
buttons on the front of the TV set.
Using the list of programmes: refer to page 12.
To access the channel or AV programme previously being watched, press the
Accessing AV programmes
Press the
button to display the last selected audio-visual programme and scan through the other audio-visual
AV
programmes.
Demo mode
This mode is used to highlight the benefits of the Hi Pix setting (see the Advanced use section, page 15).
Press the
button on the remote control to switch to Demo mode.The TV set alternates between on and off with
DEMO
the Hi Pix setting. Press the
Page 11
A
button located on the front of the set.When the set is on, the indicator on the front
+/
- buttons to switch the television on at the last channel or AV programme you were watching,
PR
PR
+/- buttons on the front of the TV set or press the relevant buttons on the remote control to
button to temporarily mute the sound. Press this button again or the
+/- button on the remote control to display the volume control bar.Then use the
) on the remote control to display the number and name of the channel you are
INFO
Permanent pr. number
function in the
button as many times as you need to exit Demo mode.
DEMO
buttons to adjust the volume.
Preferences
menu, the channel number will be displayed permanently
button
RETURN
11
Operation
+ button to restore it.
EN
Advertisement
Table of Contents
