Specific Precautions For Projection Tvs; On/Off Switch; Safety; Temperature - THOMSON RP-ITC222 Manual

Table of Contents

Advertisement

ITC222-EN
17/07/03
16:59

Specific precautions for projection TVs

On/Off switch

Refer to the picture on the inside cover of this manual.
If you are not using the appliance for a long period of time
switch it off using the on/off switch

Safety

Do not place the TV set on a surface which is unstable,
sloping or subject to vibration.
Make sure that the flooring is strong enough to support the
set's weight.

Temperature

If the temperature in the room changes suddenly or the set
is moved from a cold to a warm place, condensation may
form on the lenses, which can distort the picture.The
picture will return to normal after one or two hours'
operation.

Comfortable viewing

To make your viewing as comfortable as possible:
- Close the curtains or shutters in the room to avoid the
screen being directly exposed to sunlight.
- Avoid flooring or wall surfaces which are too shiny, as well
as any form of direct lighting on the screen.

Cleaning the screen

Use a dry soft, lint-free cloth. If necessary, wipe the screen
vertically using a soft cloth slightly moistened with water.
Important: do not use any detergents to avoid damaging
the screen.
Best viewing angle
Page 3
A
.

Choosing the ideal location

One of the main assets of your projection television is its
large screen. It can provide good conditions for comfortable
viewing at up to an 80° angle from the centre of the screen
(see below).
However, to ensure your maximum enjoyment, it is
recommended that you sit directly in front of the television,
with your eyes level with the centre of the screen at a
distance of no less than 3 metres.

Other recommendations

Before moving your projection television set:
- Unplug the power and RF cables.
- Make sure that the power cable is not caught under one of
the casters as this could damage it and cause a short circuit.
- Move the set carefully. It is equipped with casters to
facilitate its movement.
- Make sure that the screen is not hit or scored.
- Lift the set up when moving it on bumpy surfaces to
prevent damage to the casters.
It is recommended that a test card or any other fixed
picture should not be left on the screen for more than 15
minutes to prevent damage to the tubes. For this reason,
games consoles are not recommended for use with this
television.
Important: in the case of 16:9 models, the prolonged use
of 4:3 pictures (grey bars on either side of the screen) may
cause discoloration at the edge of the picture.
25°
3 m
3
Getting started
EN

Advertisement

Table of Contents
loading

Table of Contents