Vapor Clean: Assisted Oven Cleaning - Smeg SY62MX8 Instructions For Use Manual

9.5.1 Removing guide frames (where present)
Removing the guide frames and the self-cleaning panels
enables the sides to be cleaned more easily. This operation
should be carried out each time the automatic cleaning
cycle is used (on some models only).
To remove the guide frames:
1 Pull the frame towards the inside of the oven to unhook
it from its housing A, then slide it out of the seats at the
back B.
2 When cleaning is
procedures to put the guide frames back in.
9.5.2 Cleaning the door glazing
The glass in the door should always be kept thoroughly clean. Use absorbent kitchen roll; remove
stubborn dirt with a damp sponge and an ordinary detergent.
Do not use abrasive or corrosive detergents to clean the oven's door glass panels (e.g. powder products,
spot-removers and wire sponges). Do not use rough or abrasive materials or sharp metal scrapers to
clean the oven's glass doors since they may scratch the surface.
9.5.3 Cleaning the door seal
To keep the seal clean, use a non-abrasive sponge and lukewarm water. The seal should be soft and
flexible (with the exception of pyrolitic models).
In pyrolitic models, the seal may flatten over time and lose its original shape. To restore it, pinch the seal
all the way along. This also helps remove any dirt on the seal.

9.6 VAPOR CLEAN: assisted oven cleaning

VAPOR CLEAN is an assisted cleaning procedure which facilitates the removal of dirt. Thanks to this
process, it is possible to clean the inside of the oven with great ease. The dirt residues are softened by
the heat and water vapour for easier removal afterwards.
Before starting the assisted cleaning cycle, make sure that the oven does not contain any foods or large
spills from previous cooking operations.
VAPOR CLEAN assisted cleaning is available only on the main oven
Carry out assisted oven cleaning operations only when the oven is cold.
Instructions for the user
complete, repeat the above
25