Connection To The Electric Network - Saeco MAGIC M2 Technical Manual

Enter the password of the technical profile. Select "Machine settings", then "Other
settings". Enable "Water main".
Remove the lid from the water tank. Remove the cap from the water tank. Keep
the cap just removed for future use of the machine set to water tank.
Reinsert the water tank cover. Refit the protection cover as described in section
"Closing the Upper Lid". Save the settings and exit the programming menu.
At this point the machine is set for operation via the water mains and the relevant
icon appears in the top right-hand corner of the ready-for-use screen.
Do not remove the water tank while the
machine is switched on.
The machine does not recognise the presence of the tank, only the water level. In
the case of operation using the water mains, the solenoid valve opens when the
water level is below the minimum. If the water tank is not present, the water fills
the top cover tank, flows down the drain and blocks the solenoid valve. At this
point, the machine no longer runs on the water mains. You can continue to use the
machine but it must be set to water tank. To reset the machine from water main to
water tank, disable the "Water main" item in the programming menu item "Machine
settings", sub-item "Other settings" and reinsert the previously removed cap into
the water tank. Fill the water tank with fresh drinking water; do not exceed the
level (MAX) indicated on the tank.
A technician is required to restore the water mains.
5.4

Connection to the Electric Network

This operation must only be performed by
specialised technical personnel or by the
service provider.
The Maintenance Technician, who is in charge of the appliance's installation, shall
make sure that:
• the power supply system complies with the safety instructions in force;
• the voltage corresponds to that indicated on the appliance data plate.
In case of doubt, do not proceed with the
installation and ask qualified and authorised
personnel to accurately check the system.
Do not use adapters or multi-sockets.
Make sure that the power cord plug is
easily reachable after installation.
English
27