Removing Propeller; Installing Propeller - Yamaha E60H Owner's Manual

Maintenance
Check the propeller shaft oil seal for dam-

age.
EMU30663

Removing propeller

EMU29198
Spline models
(1) Straighten the cotter pin and pull it out
using a pair of pliers.
(2) Remove the propeller nut, washer, and
spacer (if equipped). WARNING! Do
not use your hand to hold the propel-
ler when loosening the propeller nut.
[EWM01891]
1. Cotter pin
2. Propeller nut
3. Washer
4. Spacer
5. Propeller
6. Thrust washer
(3) Remove the
equipped), and thrust washer.
EMU30673

Installing propeller

EMU46121
Spline models
ECM00502
Make sure to use a new cotter pin and
bend the ends over securely. Otherwise,
the propeller could come off during oper-
64
1
3
6
4
5
ZMU03228
propeller, washer
ation and be lost.
(1) Apply Yamalube Marine Grease or a
corrosion resistant grease to the propel-
ler shaft.
(2) Install the spacer (if equipped), thrust
washer, washer (if equipped), and pro-
peller on the propeller shaft. NOTICE:
Make sure to install the thrust washer
before installing the propeller. Other-
wise, the lower case and propeller
boss could be damaged.
(3) Install the spacer (if equipped) and the
washer. Tighten the propeller nut to the
specified torque.
2
1. Cotter pin
(if
2. Propeller nut
3. Washer
4. Spacer
5. Propeller
6. Thrust washer
Propeller nut tightening torque:
34 N·m (3.4 kgf·m, 25 lb·ft)
(4) Align the propeller nut slot with the pro-
peller shaft hole. Insert a new cotter pin
[ECM01882]
1
3
6
2
4
5
ZMU08160