Adaptation To Different Types Of Gas - Smeg SC341GX-8 Manual

Instructions for the installer

10. ADAPTATION TO DIFFERENT TYPES OF GAS

Before any intervention that requires access to live parts, disconnect the
appliance from the power supply.
The appliance is preset for natural gas G20 (2H) at a pressure of 20 mbar. In the
case of operation with other types of gas, the burner nozzle must be changed
and the the gas tap adjusted. To change the nozzle, proceed as described in the
following paragraphs.
10.1 Adjusting the oven burner
To adjust the oven burner you need to open
the oven door and carry out the following
operations:
• remove all accessories from inside the
oven (trays, racks and any steel
runners);
• lift up the oven surface and pull it
outwards as shown in the figure.
10.1.1 Replacing the nozzle
•
Loosen the oven burner fixing screws
A and B.
• Move away the lock that secures the
thermocouple and igniter to the
burner with screw A.
• Slide the burner outwards until the
nozzle is accessible.
• Using a 7mm socket wrench, replace
the nozzle, inserting a new nozzle
suitable for the type of gas to be used
(see "10.2
characteristics table").
Burner and nozzle
A
B
71