Installing The Appliance - Smeg SC061X-8 Manual

Instructions for the installer

10.INSTALLING THE APPLIANCE

10.1 Electrical connection
The identification plate bearing the technical data, serial number and brand
name is visibly positioned on the appliance.
Do not remove this plate for any reason.
The appliance must be connected to earth in compliance with electrical system
safety regulations.
If a fixed connection is being used, fit the power line with an omnipolar circuit-
breaker in accordance with the installation rules, located in a position which is
easy to reach and near the appliance.
If a plug and socket connection is being used, make sure that the plug and
socket are compatible. Avoid use of adapters and shunts as these could cause
overheating and risk of burns.
On ovens with hob controls the power supply lead is not supplied. Use a
H05V2V2 rubber cable and when positioning it ensure that it does not touch the
metal parts of the appliance's external casing. To access the terminal board,
remove the appliance's back cover by unscrewing the relative screws. If
necessary, change the positions of the jumpers on the terminal board as shown,
then connect the wires, making sure that the earth wire is at least 20 mm longer.
Fix the power supply lead to the appliance using the cable clamp provided.
WARNING: The values indicated above refer to the cross-section of the internal
conductor.
91