Smeg MCP48X Manual page 30

10.6 Removing guide frames
10.7 Pyrolysis: automatic oven cleaning
Pyrolysis is an automatic high-temperature cleaning procedure which causes
dirt to dissolve. Thanks to this process, it is possible to clean the inside of the
oven with great ease.
During the first automatic cleaning cycle, unpleasant smells may occur due to the normal
evaporation of oily manufacturing substances. This is an absolutely normal phenomenon
which disappears after the first cleaning cycle.
Before starting the automatic cleaning cycle, make sure that the oven does not
contain any foods or large spills from previous cooking operations.
During the pyrolysis cycle, a door locking device makes it impossible to open
the door.
If the oven is installed under a hob, make sure that the burners or electric
hotplates on the hob remain switched off during the automatic cleaning cycle.
74
Instructions for the user
Removing the guide frames makes it easier to
clean the side parts of the oven, and it also
needs to be done whenever the automatic
cleaning cycle is used (only available on some
models).
• To remove the guide frames, pull the
frame towards the inside of the oven to
unhook it from its housing A, then slide it
out of the seats at the back B.
• When cleaning is complete, repeat the
above procedures in reverse order to put
the guide frames back in.
(on some models only)