Table of Contents
Advertisement
Preparing the Remote Control
Inserting
batteries
into the remote
control
Checking Accessories
Please confirm that the following were received with the
ptayer.
Audio cord
Video cord
Master-Slave
control
cord
1
Push down on the tab on the battery
compartment
cover, and pull out in the
direction indicated by the arrow.
2
insert batteries.
Make
sure
to match
the plus (+) and minus
(-) polarity
guides
on the batteries
with
the marks
inside
the battery
compartment.
Remote
control
unit
3
Close the cover.
8
AA/R6P
batteries
Operating
instructions
(this manual)
Warranty
card
(U,S,
and Canadian
models
only)
Notes
• Do not mix old and new batteries.
• When replacing battedes,
use all new batteries.
• When nor using the remote _ontrol for a long period of time
(over 1 month), remove the batteries to avoid possible damage
from battery corrosion, If batten/leakage
occurs, wipe the
batten/liquid
from the battery component, then insert new
batteries,
Remote
control
operation
When operating the remote control, point it at the remote
sensor ([]) located on the player's front panel. The
remote control can be used up to 7 m (23 feet) from the
player and within a 30 ° angle on each side of the sensor.
Notes
• Exposing the remote sensor to direct sunlight or strong light
may cause fault,/operation.
• When Master-Slave
connections are made to another DV-F727
to create a 601 _isc
changer, only the remote sensor on the
first DV-F727 will accept signals from the remote control
(page 66).
• If the CONTROL
IN jack on the player's rear panel is connected
to the CONTROL OUT jack of another component, point the
remote control at the other component to operate the player,
Operation will not be possible when pointed at this player
(page 19).
Advertisement
Table of Contents
