Table of Contents
Advertisement
Other problems
Problem
There are humming
noises
A programme does not
start
Only the Start/Add laun-
dry sensor control
flashes slowly when the
programme is running.
The tumble dryer is
switched off.
The drum lighting does
not come on.
Cause and remedy
The compressor is operating.
These noises are quite normal and do not indicate a
fault.
No obvious cause.
Connect the tumble dryer to the mains
Turn on the tumble dryer
Close the door
Check whether the mains fuse has tripped
Has there been a power cut? When power is restored
any previously running programme will restart auto-
matically.
Once the programme has been running for
10 minutes, the indicators go out. The Start/Add laun-
dry sensor control flashes slowly. This is not a fault,
but a normal function to help save energy.
Touch a sensor control to switch on the indicators.
See " Control field standby status" in "Programmable
functions".
The tumble dryer switches off automatically after
15 minutes if no further selections are made. This is
not a fault, but a normal function.
Select a programme.
To save energy, the drum lighting goes out automatic-
ally after a set time and after the programme starts.
Switch the dryer off and then on again.
To switch the drum lighting on, open the door of the
tumble dryer.
The drum lighting is faulty.
The drum lighting is designed to last a long time and
should not normally need to be replaced.
If you have tried everything but the drum lighting still
does not come on, contact the Miele Customer Ser-
vice Department.
Problem solving guide
53
Advertisement
Table of Contents
