Direct Tuning - Technics SA-DX940 Operating Instructions Manual

_vm i[ ;I i i T,H_I,_*] III i[=]l'_J'_l
1
2
3
1
TUNER/
_.Cntz i-) "_ F')
Fr : i_ !l'_.
Sel!ctldband
DIRECTTIJ_
D_CENTER
I . II_
i,. 7 :'=':_ I _ I _ Iw..
TLINEO
i
II I
I I
k_L_
The radio
Specify the frequency using the numbered buttons on the remote
control to directly tune to the station.
1
Press [TUNEN/BAND].
This will set the remote control to operate the tuner.
The selector on the receiver will change to "TUNER",
Each time the button is pressed, the band wilt change as
follows,
FM _ AM.
2
Press [DIRECTTUNING/DISC ENTER].
While cursor display is flashing (approx. 10 seconds)
Press the numbered buttons to enter
the frequency.
Tuning interval FM: 0.1 MHz
AM: 10 kHz
If the desired FM frequency is 107.9 MHz, press
_.--_%-_-_.
If the frequency has been input correctly, the displayed
frequency wii! blink once.
1. If no button is pressed while the cursor display is flashing,
the display will return to the frequency which is currently
being received.
To re-specify the frequency, repeat the procedure from
step 2.
2. If the frequency has not been input correctly, "ERROR"
wii] be displayed.
In this case, re-enter the frequency•
RQT5308