Direct Access Tuning - Technics SA-GX670 Operating Instructions Manual

16
Direct access tuning
Specify the frequency using the numeric buttons to directly tune
to the desired broadcast station.
For SA-GX670
For SA-GX470/SA-GX370
FM MODE
Press TUNER.
Press BAND to select "FM","MW"
or "LW".
Press DIRECT TUNING.
While cursor display is
flashing (approx. 10
seconds)
Press the appropriate numeric but-
tons to enter the frequency.
If the frequency has been input correctly, the fre-
quency display will blink.
1. If no button is pressed while the cursor display
is flashing, the display will return to the frequen-
cy which is currently being received. To re-
specify the frequency, repeat the procedure
from step 3.
2. if the frequency has not been input correctly,
an error message will be displayed. In this
case, re-enter the frequency.
If the desired FM frequency is 107.90
MHz
[> fo] > Z} > [8] > (9
*Uoga, QUARTZ LOCK
iP
illuminates when tuned
When the FM stereo broadcast is received:
This unit will automatically switch to FM stereo reception and the
FM stereo indicator will illuminate.
AUTO QUARTZ LOCK
MANUAL
seewers STEREO ff P11 C7}
Ph eh
Hiuminates
If noise is excessive in the FM stereo mode
Press FM MODE. (The FM stereo indicator will switch off.)
The broadcast will be monaural, but noise will be reduced. If the
button is pressed once more, stereo mode will be resumed.
To change the MW frequency step
Press and hold BAND for about 3 seconds.
(The frequency step changes to 10 kHz per step.)
To return to the previous step, press and hold BAND for about 3
seconds again.