Listening To Radio Broadcasts Oon. Ccecscsseesstssseeessseeseee; Sequential Tuning Suaran; Idendnanins; Ness Cinievedionigioleaveners - Technics SA-EX510 Operating Instructions Manual

FM AUTOMOND
me t
flét
ff?
SA-EX510 t SA-EX410/EX310
tovusnerruoraopnaonnasa
SA-EX410/EX310 a 71S
(approx. 10 seconds)
~~ ~ `
~
=
~ H
umieram rr eee eee rae,- mR RE RR eeaeee Pr PTE RY e a a:
EEE EAE.
meme ee TNS ore
|
| Listening to radio broadcasts |
Sequential tuning A)
You can use the tuning buttons to tune-in radio broadcasts.
EB Press TUNER.
2 Press BAND to select "FM" or "AM".
Press TUNING (V) or (A) to tune to the desired
broadcast.
FM:0.2 MHz
AM:10 kHz
"QUARTZ LOCK" lights up when tuned.
"STEREO" lights up when an FM stereo broadcast is
received.
Tuning intervals
To make an automatic search for broadcast stations
If TUNING (V) or (A) is held down for an instant until the
frequency begins to scroll, the broadcast stations can be
tuned in automatically when a broadcast station is found.
Tuning may stop automatically if any jamming is encountered.
If noise is excessive in the FM stereo mode
Press FM AUTO/MONO.,
(The "STEREO" indicator will go out, and the "MONO" indicator
will light up.)
The broadcast will be monaural, but noise will be reduced.
If the button is pressed once more, the stereo mode will be
resumed.
Direct access tuning E
(Only available from the remote control.)
Specify the frequency using the numeric buttons on the remote
control transmitter to directly tune to the desired broadcast station.
First select between FM and AM with the BAND button on the
receiver.
Press TUNER.
This will set the remote control to operate the tuner.
For SA-EX510
Press DIRECT TUNING.
For SA-EX410/EX310
Press DIRECT TUNING/DISC ENTER.
Press the appropriate numeric buttons to enter the
frequency, while cursor display is flashing.
FM:0.1 MHz
AM:10 kHz
If the desired FM frequency is 107.9 MHz, press
[+ o- F- B
If the frequency has been input correctly, the displayed
frequency will blink once.
Tuning intervals
1. If no button is pressed while the cursor display is flashing,
the display will return to the frequency which is currently
being received. To re-specify the frequency, repeat the
procedure from step 2.
2. If the frequency has not been input correctly, "ERROR"
indication will be displayed. In this case, re-enter the
frequency.