Preference; Backlight Setting; Panel Calibration - Fujitsu UTY-DCGYZ3 Operation Manual

3-3. Preference

When the password is set at start-up, enter the password. (Refer to 3-3-5.)
3-3-1. Backlight Setting
Arrange the LCD backlight.
(1)
 

3-3-2. Panel Calibration

Calibrate the position of LCD panel.
The buttons on the touch panel operate normally by calibration.
Only procedure (4) is displayed at initial setting.
(1)

4
En-34
(3)
(2)
3
(3)
(2)

5
3
(1) Tap the MENU button.
(2) Tap the [Preference].
(3) Tap the [Backlight Setting].
(4) Set the item and tap the [OK] button.
No. Item
"Automatic Off Sets the automatic light-off time.

Time" [1 minute to 30 minutes]
Sets the brightness.
"Brightness"

Dark 1↔2↔3 Bright
"Screen lit Selects "Enable" or "Disable" of the
while in error setting for emergency light-on.
3
status" "Enable" / "Disable"
(1) Tap the MENU button.
(2) Tap the [Preference].
(3) Tap the [Panel Calibration].
(4) Tap the center of + marks which appear in turn at 5 places (
to 5).
Re-check Panel Calibration screen is displayed. Touch the 5
places again.
Description