Table of Contents
Advertisement
INSTALLATION
Installation Opening
This unit can be installed in any dashboard Having an
opening as shown the right figure.
If installation angle exceeds 30 horizontal, the unit may
not perform properly.
To Install the Car Radio
1. Make sure the ignition is turned off, and then disconnect the cable from the vehicle
battery's negative (-) terminal. You never want electricity running while you install this
double-DIN car receiver.
2. Before installation, remove the transport screws, disconnect the wire harness and the
antenna. Remove the detachable faceplate from the car receiver.
3. Attach the "L " brackets (2pcs) on the both sides of the car receiver with screws(M5 x 8BM)
as shown as the below figure. The others fixing screws that fix the other terminal of the "L"
metal bracket, please buy from your dealer according to the drilling of holes size.
4. Consult with you nearest dealer if installation requires the drilling of holes or other modifi-
cations of the vehicle.
5.
Install the car receiver in the dashboard.
6.
Connect the wire harness & the antenna to the car receiver (see "Electrical Connections")
being careful not to pinch any wires or cables.
7. Install the detachable faceplate & plastic outer trim ring onto the car receiver.
8. Reconnect the battery and run through all of the options on this car receiver to ensure that
everything is working correctly.
9.
Particulars will vary widely depending upon the kind of your car and the car you intend to
install it in.
Please choose the correct installation method according to the actual situation
of your car.
Always contact the car dealer or manufacturer if you have any questions.
Remove the transport
screws before installation.
2
103 mm
182 mm
Advertisement
Table of Contents
