CONTENTS Installation & Removal ........3 DIN Mount ............ 3 Installing the unit ........... 3 Removing the unit ........4 Wiring Connections ........5 Operation ............. 6 Location of Keys ..........6 Powering On/Off ..........7 Audio Adjustment .......... 7 Time ..............
INSTALLATION Choose the mounting location where the 1. Make sure the ignition is turned off, and unit will not interfere with the driver. then disconnect the cable from the vehicle Before finally installing the unit, connect battery’s negative (-) terminal. the wiring temporarily and make sure it is 2.
REMOVING THE UNIT 1. Make sure the ignition is turned off, then disconnect the cable from the vehicle battery’s negative (-) terminal. 2. Remove the metal strap attached the back of the unit (if attached). 3. Lift the top of the outer trim ring then pull it out to remove it.
OPERATION Powering ON/OFF Aux-In Press PWR button (3) to turn on the unit. When A 3.5mm audio cable is required (not included) the unit is on. Press and hold for 2 seconds to Track Functions, Play/Pause, will not be used for turn off the unit.
In DX mode it will increase the receiving manual of your mobile phone on how to sensitivity when you search the station. operate Bluetooth.) 2) “BOSS AUDIO” should appear in the list on your mobile phone, please select “BOSS STEREO/MONO AUDIO”...
OPERATION Audio Streaming (A2DP) Connect/Disconnect Bluetooth Press MODE to enter BT mode. Press and Hold for 3 seconds to Note: BT will only be active when there is a disconnect. device that has been paired and is Press and Hold it again to connect the connected.
REMOTE CONTROL (OPTIONAL) KEY & CONTROL Power ON/OFF 2. VOL+ Volume Up 3. BAND Band Select (FM1, FM2, etc…) 4. SEL Audio Adjustment/Enter Radio: Seek/Scan MP3 mode: skip to the previous file or fast reverse 6. EQ Press it to select desired audio equalization. 7.
TROUBLESHOOTING Before going through the checklist, check wiring connection. If any of the problems persist after checklist has been made, call our Tech Dept. (M-F, 8:30a-5p PST) 805-751-4853 Symptom Cause Solution The car ignition switch is not on. Turn the key to the “ACC” or “IGN” Does not power on position The fuse is blown.