PRECAUTIONS Lithium Battery Cell Warnings Cell leakage may cause damage to the remote control. Do not throw cells into as this may cause an explosion. Keep battery cells out of reach of children. Take Precaution Some MP3/WMA files may not be playable. Be sure to lower the volume before switching off the unit or the ignition key.
INSTALLATION Installation Procedures First complete the electrical connections and then check for correctness. Installation Opening 2.05 inch 7.20 inch MOUNTING SLEEVE This unit can be installed in any dashboard Having an opening as shown above . Insert mounting collar into the dashboard and bend the mounting tabs out with a screwdriver.
INSTALLATION(CONT.) - Only use speakers with 4 ohms impedance. - Do not attach the control panel to the chassis before wiring is complete. - The maximum current of the auto antenna is 200mA. Wiring Connections WIRING DIAGRAM White:Front Left CH RCA Output Radio Antenna AUX-Left input AUX-Right input...
CONTROL PANEL BUTTON LOCATIONS OPERATION 1.POWER/SRC to turn off the unit. RADIO,BT, USB & CARD , AUX IN,modes (if there are USB and SD card inside the unit). radio and Aux. When the user inserts a USB flash drive or SD Card, their respective logos will illuminate on the display. 8.
OPERATION In the radio mode, rotate the volume knob to increase or decrese the volume level of the sound Loud Stereo In the USB or SD card mode, press the volume knob to enter the EQ function that the audio At the radio status,press and hold the VOL button to enter switch state of the US(USA) and EU (EUROPE) frequency,then rotate the VOL knob to select US frequency or EU frequency,after selecting US or EU frequency,the system will switch to the selected frequency 3 seconds later.
BLUETOOTH OPERATION Pair and Connect Prior to using the Bluetooth device as a handsfree system for a Bluetooth-enabled mobile phone for the time, you must pair and connect the two devices as follows: In any mode, prior to pairing and connecting, the BT logo in the LCD indicating that no device is connected.
SPECIFICATIONS General Power supply Requirement : DC 12V Maximum power output : 50W X 4CH Speaker impedance : 4 - 8 Ohm Unit Dimensions(WxHxD) : 7.0 X 2.0 X 3.8 inch Weight : 1.54 Lb (0.7 kg) Fuse : 15 A RADIO Frequency Range USA / EUROPE: 87.5 MHz - 107.9 MHz / 87.5 MHz - 108.0MHz...