Assign Inputs Menu, Basic Mode - Weil-McLain SlimFit 2 Series Manual

SlimFit ® Series 2

ASSIGN INPUTS menu, BASIC mode

Boiler Model, Altitude and Fuel Type are
critical settings
result in severe personal injury, death or sub-
stantial property damage.
Figure 64
SlimFit BASIC mode ASSIGN INPUT options (USER MODE must be set to BASIC) — see Figure 65, page 72
and Figure 66, page 72 for explanation of AUX PUMP/OUTPUT settings
Screens shown above are typical only
Actual screens depend on control
settings chosen
Part number 550-100-561/0224
commercial condensing gas
Failure to set correctly could
MENU ITEM
Overview
INPUT 1
INPUT 2
INPUT 3
- — Boiler Manual
fired water boiler
1. Access contractor menus by pressing and holding the UP and
DOWN arrow keys at the same time for 7 seconds.
2. See Figure 61, page 68 for the screen sequences up to the
CONTRACTOR menu.
DESCRIPTION
• There are three priority levels defined by the set-
tings chosen in Figure 63, page 70.
• For DHW priority, make sure PRIORITY 1 is de-
fined for a DHW system.
• If DHW priority is required and analog input is
used for space heating, assign INPUT 2 to the
DHW aquastat (TT2) and INPUT 1 as PRIOR-
ITY 2 and SOURCE set to 0-10V.
• Assign priority (system type) for INPUT 1 — op-
tions are:
• PRIORITY 1 — assigns INPUT 1 to PRIORITY 1
system.
• PRIORITY 2 — assigns INPUT 1 to PRIORITY 2
system
• PRIORITY 3 — assigns INPUT 1 to PRIORITY 3
system
• AUX PUMP/OUTPUT
• OFF
• NOTE: For INPUT 1 only, select SOURCE = TT1 for
thermostat input or 0-10V if analog input is required.
• Assign priority (system type) for INPUT 2 — op-
tions are:
• PRIORITY 1 — assigns INPUT 2 to PRIORITY 1
system.
• PRIORITY 2 — assigns INPUT 2 to PRIORITY 2
system
• PRIORITY 3 — assigns INPUT 2 to PRIORITY 3
system
• AUX PUMP/OUTPUT
• OFF
• Assign priority (system type) for INPUT 3 — op-
tions are:
• PRIORITY 1 — assigns INPUT 3 to PRIORITY 1
system.
• PRIORITY 2 — assigns INPUT 3 to PRIORITY 2
system
• PRIORITY 3 — assigns INPUT 3 to PRIORITY 3
system
• AUX PUMP/OUTPUT
• OFF
71