Problems - Causes - Solutions - Saeco FOCUS PRO-DISC SUPO48 Operation And Maintenance Manual

English
Warning Signals
11.2

Problems - Causes - Solutions

The following table indicates the possible error or alarm causes which may lead to a partial or total shutdown of
the appliance.
Error code
E5 Error 5:
COD_WATER_CIRCUIT_FAILURE
Indicates a fault regarding the water circuit for hot water/coffee:
the pump has performed the three attempts of priming the circuit
E6 Error 6:
COD_EV_DRV_FAILURE
Indicates that one or more solenoid valves are in short-circuit and therefore they cannot be used
E10 Error 10:
COD_NTC_C_SHORT_FAILURE
Indicates that the NTC temperature sensor of the coffee boiler is in short-circuit
E11 Error 11:
COD_NTC_C_OPEN_FAILURE
Indicates that the NTC temperature sensor of the coffee boiler is not connected
E14 Error 14:
COD_HC_TIMEOUT_FAIL
Indicates that the coffee boiler supply is not connected
E19 Error 19:
COD_Z_CROSSING_FAILURE
E20 Error 20:
COD_HC_OVER_TEMP_FAILURE
Indicates that the coffee boiler is overheated
64
The machine requests to close the capsule tray.
Turn off the machine.
Turn it back on after 30 seconds.
Try this 2 or 3 times.
If this signal appears again, contact the service provider and provide the code shown in the
display.
How to reset the message
Description