Table of Contents
Advertisement
Troubleshooting
EN
Be aware that new software may change the functionality of your receiver.
Should you experience any difficulties with the operation of your receiver, please
consult the relevant section of this manual, including this section. If the problem
cannot be solved, call your customer service adviser.
Problem
The LED on the front panel
does not light up.
No sound or picture but the
front panel LED is lit in red.
No sound or picture but the
front panel LED is lit in
green.
The remote control does not
operate your receiver.
On-screen display working
but there is no reception
Intermittent reception
The picture is not sharp and
on-screen text is difficult to
read.
28
Possible cause
Faulty power supply
Receiver in standby
Poor signal
Receiver in TV mode
Poor SCART connections
Poor reception/signal
Faulty connections
TV SCART output format not
set to RGB
Action
Check that the power cord is
correctly connected. Disconnect
this cord and reconnect it to
ensure it is in place.
Check that the power is available at
the wall socket.
Press P+, P-, or any number key of
the remote control. If the receiver
does not wake up,
press
on the front panel.
Check the connections at the wall
socket and receiver.
Press TV/STB on the remote
control once or twice.
Check the SCART connections.
Make sure the receiver is on.
Make sure you are pointing your
remote control at the receiver
front panel.
Check the batteries in your remote
control.
Check the installation.
Check all connections and cable.
Change setting of the TV output
signal item to RGB from the TV
Configuration screen.
Advertisement
Table of Contents
