Philips DTR2520 User Manual page 19

- Move to the desired programme using the arrow keys
and the colour keys.
- Press the blue colour key to set a recording timer on
the selected programme.
- Enter your PIN code if necessary, and then set the
recording settings using the arrow or number keys as
appropriate. By default, the settings correspond to the
selected programme. For more information, refer to
paragraph Timers Manager.
- Press EXIT to save and exit.
Setting a timer while watching digital
TV or listening to digital radio
- Press TIMER.
- Scroll to a disabled timer to add a new timer and
press OK.
- Set the recording settings using the arrow or number
keys as appropriate. For more information, refer to
paragraph Timers Manager.
- Press OK to confirm.
Setting or modifying a timer from the
Timers Manager
- Scroll to the existing timer you want to modify or
select a disabled timer to add a new timer.
- Enable the timer by setting the Status to Enabled in
case of a new timer.
- Set the settings using the arrow or number keys as
appropriate. For more information, refer to paragraph
Timers Manager.
- Press EXIT to save and exit.
Deleting an active timer
A timer is active as signalled by the front LED lit in
dimmed green in TV or Radio mode or dimmed orange
if your receiver is in standby.
To delete the active timer:
- If your receiver is in standby, press P+, P-, or any
number key of the remote control.
- Press the key sequence TIMER then 0.The LED is
no longer dimmed and you can change channels.
When a recording timer is active, you should not
change digital channels or you will record the
channel you tune to. However you can switch to
analogue TV using the TV/STB key and zap
through analogue channels.
EN
19