8.3 The drying cycle is long and the washing is still humid
Has the washing been through
a sufficient spin cycle, or is the
load quantity appropriate?
Y
E
S
Are the fluff filters clean and is the
condensation water tank empty?
Y
E
S
Does the compressor start a few minutes
after the programme has started without
any alarm being triggered?
Y
E
S
Check the performance of the
compressor comparing the
temperature data shown in the
service manual.
Is the compressor performance data
the same as that specified?
Y
E
S
Appliance OK, run the diagnostics
programme.
Technical Support - A.D.L.
Spin the washing before placing it
inside the tumble dryer and check
NO
Clean all the filters and empty out the
NO
Check for any alarms and remedy
NO
them according to the alarms table.
Replace the complete base or
NO
recharge the closed gas circuit.
59/66
the load quantity.
condensation water tank.
R134a 270g
599 74 32-54 Rev.01