Table of Contents
Advertisement
22
Daily use
Putting in extra items or taking items out before end of programme
1. Open loading door.
WARNING!
Laundry and drum can become hot. Risk of burns!
2. Load or remove laundry items.
3. Close loading securely. Lock must audibly lock.
4. Press the START PAUSE START PAUZE button to continue the drying cycle.
Drying cycle complete / removing laundry
Once the drying cycle is complete, display shows a blinking "0", under anti-
crease
acoustic signal sounds intermittently for about one minute.
The drying cycles (except for the SHOES RACK and WOOL RACK programmes) are
automatically followed by an anti-crease phase which lasts around 30 minutes.
The drum rotates at intervals during this phase. This keeps the laundry loose and
free of creases. The laundry can be removed at any time during the anti-crease
phase. (The laundry should be taken out towards the end of the anti-crease phase
at the latest to prevent creases from forming.) If LONG ANTI-CREASE
has been selected, the anti-crease phase is lengthened by 60 minutes.
1. Open door.
2. Before removing the laundry, remove fluff from the micro-fine filter. It is best
to use a damp hand for this purpose. (See "Care and cleaning" chapter.)
3. Remove laundry.
4. Turn the programme selector to OFF UIT.
After each drying cycle:
- Clean the micro-fine filter and fine filter
- Drain the condensed water container
(See chapter "Care and cleaning".)
5. Close the door.
icon appear dash. If the BUZZER ZOEMER option has been chosen, an
function
Advertisement
Table of Contents
