Env06 Tumble Dryers Alarms Table Summary - Electrolux 6 Series Service Manual

7.5 ENV06 TUMBLE DRYERS ALARMS TABLE SUMMARY

Condensation water filling pump
Ex21
alarm
Condensation water filling pump
Ex22
detection alarm
Conductivity sensor frequency
Ex31
too HIGH
Conductivity sensor frequency
Ex32
too LOW
Ex45 Door closed sensing alarm
Ex51 Motor power triac short-circuited
Ex52 Motor thermal cut-out triggered
Technical Support - A.D.L.
Full name
 The cycle is suspended.
 If detected during configuration, the cycle start will
not be permitted.
 The cycle is suspended.
 If it is detected before the cycle starts, the cycle
start will not be permitted.
 The cycle is suspended.
 If it is detected before the cycle starts, the cycle
start will not be permitted.
 The cycle is suspended.
 If it is detected before the cycle starts, the cycle
start will not be permitted.
 The cycle is suspended.
 If it is detected before the cycle starts, the cycle
start will not be permitted.
Action
No action.
No action.
50/66
Notes and possible causes
 Pump disconnected (wiring or connector error).
 Pump faulty.
 Water filling pump TRIAC error (short-circuit,
diode mode, open circuit) (power board error).
 Pump TRIAC detection circuit error
(main board error).
Only active during diagnostics of the HUMIDITY
SENSOR SHORT-CIRCUIT.
 The oscillation frequency is out of range
(main board failure).
Only active during diagnostics of the HUMIDITY
SENSOR SHORT-CIRCUIT.
 The drum is not short-circuited.
 Wiring error.
 The oscillation frequency is out of range
(main board failure).
Error in the door closed detection circuit.
 Door micro-switch faulty or disconnected.
 Main board error.
 Motor faulty.
 Faulty wiring.
 Main circuit board faulty.
 Motor faulty.
 Motor thermal cut-out has triggered.
 Faulty wiring.
 Main circuit board faulty.
599 74 32-54 Rev.01