Installing The Pdp002Z - Toshiba TOSVERT VF-AS1 Instruction Manual

3. Installing the PDP002Z

Install the PROFIBUS option to VF-AS1/PS1 as follows:
* When this option is used together with the IO card option, attach this option to the front
panel side.
(1) Turn off input power of VF-AS1/PS1 and wait for at least 15 minutes and then check
that the CHARGE lamp on VF-AS1/PS1 is no longer lit.
(2) Securing the option to the inverter
a) Insert a flat-blade screwdriver in each of the two holes at the upper part of the front
b) Install the
c) Make sure the option is securely attached to the inverter. Then, check whether the
d) Insert the tabs at the lower part of the front cover into the slots at the lower part of
e) Stuck the enclosed "LED name label" on the option LED display part of a front
cover.
* When installing this option to below capacities,
remove the Add-on type option case.
VFAS1: 200V 55, 75kW
400V 90 - 500kW
VFPS1: 200V 55 - 90kW
400V 90 - 630kW
b)
LED name label
ST
DX
MNS
MNS
MNS
efesotomasyon.com -Toshiba inverter,drive,servo,plc
panel, release the panel mounting tab by pushing the screwdriver down, and
remove the front panel cover.
option in the inverter by fitting the tabs on the lower side of the
the slots at the lower part of the inverter front panel.
plastic bosses on the inverter case have fitted in the holes at the upper and lower
parts of the .
option
the inverter to attach the front cover to the inverter.
a)
c)
e)
- 9 -
E6581279⑤
option
d)
into