Connecting To The Network; Installation Method - Toshiba TOSVERT VF-AS1 Instruction Manual

efesotomasyon.com -Toshiba inverter,drive,servo,plc

4. Connecting to the network

4.1. Installation method

(1) Using the DIP switchon the PROFIBUS option, seta station address. (Refer to Section
4.2.)
(2) Connect a PROFIBUS connector to the PDP002Z. (Refer to Section 2.1.)
* If the PDP002Z is located at an end of the bus, connect a terminal resistor to it.
(When using a connector with
(3) Once all the parameters are set, the power must be cycled to the VF-AS1/PS1 for
these changes to take effect. (Refer to Section 5.)
termination resistor , set it ON.)
- 10 -
E6581279⑤