Installing The Pdp002Z - Toshiba TOSVERT VF-AS1 Option Instruction Manual

3. Installing the PDP002Z

Install the PROFIBUS option to VF-AS1 as follows:
* When this option is used together with the IO card option, attach this option to the front
panel side.
(1) Turn off input power of VF-AS1 and wait for at least 15 minutes and then check that the
CHARGE lamp on VF-AS1 is no longer lit.
(2) Securing the option to the inverter
a) Insert a flat-blade screwdriver in each of the two holes at the upper part of the front
panel, release the panel mounting tab by pushing the screwdriver down, and remove
the front panel cover.
b) Install the option in the inverter by fitting the tabs on the lower side of the option into
the slots at the lower part of the inverter front panel.
c) Make sure the option is securely attached to the inverter. Then, check whether the
plastic bosses on the inverter case have fitted in the holes at the upper and lower
parts of the option .
d) Insert the tabs at the lower part of the front cover into the slots at the lower part of
the inverter to attach the front cover to the inverter.
e) Stuck the enclosed "LED name label" on the option LED display part of a front cover.
b)
LED name label
ST
DX
MNS
MNS
MNS
a)
c)
e)
- 9 -
E6581279
d)